Owner's Manual Audio Recorder AR-200

56
MODE SW Settings
MODE Switch Specifications
In addition to the REC MODE switches (p. 20-22), the AR-
200’s bottom panel also houses the MODE switches. Various
applications are possible by changing the settings of the
MODE switches.
Each switch is ON when in the upward position, and OFF
when in the downward position.
When the AR-200 is shipped from the factory, all switches
will be OFF.
* Use a pointed object to change the ON/OFF settings of the
MODE switches.
fig.mode-01j
Playback Mode Settings (SW 1, 2)
The AR-200’s playback modes are set by means of varying
combinations of ON and OFF settings for SW 1 and 2.
fig.mode-02
Types of Control Input Playback (p. 28)
Output Level Settings (SW 3)
Specifies the output level. Set this in accordance with the
specifications for the device to which the playback is being
output.
OFF: -10dBV
ON: +4dBu
AR-LINK Settings (SW 4)
When using AR-LINK, set this to “SLAVE.”
OFF: OFF
ON: SLAVE
Switch Protect Setting (SW 5)
This setting prevents malfunctioning caused when buttons
are pressed by mistake. Setting Switch Protect to “ON”
disables any action from the buttons on the front panel if
they are pressed.
OFF: OFF
ON: ON
Terminal Rec Settings (SW 6)
When conducting Terminal Rec, set this to “ON.”
OFF: OFF
ON: ON
Playback By Card Data
Direct Playback (Last-In)
Binary Playback
Interval Playback
OFF
ON
OFF
ON
OFF
OFF
ON
ON
PLAYBACK MODE
SW 1
SW 2
AR-200_e.book 56 ページ ２００３年７月１４日 月曜日 午後１時１１分