Owner's Manual

Connecting Other Equipment (continued)

Introduction

If you’re using condenser mics, you must make settings so

that phantom power is supplied to them.

NOTE

• Supplying phantom power to a dynamic mic or an audio

playback device will cause malfunctions. Also, the CD-2

cannot be used with devices other than condenser mics

that require phantom power (such as the BOSS Direct

Box DI-1).

Carefully read the owner’s manual for the mic you’re

using, and be sure to set the phantom power switch

to “OFF” unless you are using a condenser mic that

requires phantom power.

Connecting a mic to the XLR type MIC 1

(or MIC 2) jack

MEMO

• Phantom power is not supplied to the phone type MIC 1

jack and MIC 2 jack located on the front panel. If your

mic requires phantom power, you must connect the mic

to the XLR type MIC 1 jack (or MIC 2 jack) located on the

side panel.

Turn on the power of the CD-2.

Page 24, “Turning the Power On”

Slide the phantom power switch located

on the side panel toward the right to the

“ON” position.

Connecting Condenser Mics

Phantom power switch