User guide

Cut Media After Printing-

Check this option to cut the media after the output is complete. Please consult "Remove the Material

- Cut the Material from the Roll - When sending a material-cutting command from the computer to separate the material

automatically" in the CAMM JET User's Manual for more information.

Print Crop Mark-

When this option is checked, the printer will add automatically a crop mark to the output. This option has the

same effect with the setting done in the printer panel (CROP MARK - ENABLE).

By adding the crop mark to the output, you can take out the print from the printer, then set it back and perform the contour cut

with correct alignment. Please consult "User's Reference - Remove the Printed Material, then Reload the Material and Perform

Cutting - Setting the Base Point and Align Point" in the CAMM JET User's Manual for more information.

See the procedures below to print, laminate then cut a design file with Print and Cut data.

Select "Print Only" for the "Send" mode in General tab. Open the Print tab and click on the Driver Option button to display the

Driver Options dialog. Check the "Print Crop Mark" option. After these settings, CAMM JET will print only adding the crop mark

to the output.

Remove the print out from the printer and laminate it. Follow the instructions from the section "User's Reference - Remove the

Printed Material, then Reload the Material and Perform Cutting - Setting the Base Point and Align Point" in the CAMM JET User's

Manual to set the media back in the printer, and adjust the base point and the aligment based on the crop mark.

Then choose "Contour Only" for the "Send" mode in the General tab. Open the Print tab and click on the Driver Options button

to display the Driver Options dialog. Uncheck the "Print Crop Mark" option. After these settings, CAMM JET will only process

the contour cut.

Cut tab

The Cut tab displays cut settings.

Resolution-

Changing this value from the default is not recommended.

Passes-

Specify how many times the blade will move over each line.

Curve Quality-

Select how smooth you would like the curves to be.