User`s manual

10
Cut/Plot Dialog Box
The Cut/Plot dialog box gives you complete control over how your job is produced. The Cut/Plot
dialog box displays when you access the Cut/Plot from your application. The Cut/Plot dialog box
contains two tabs: General and Advanced.
The General Tab
The General tab is where you specify the size and location of your design on the media.
Material
Use the Material group box to specify the size of the media. The sizes that display are
appropriate for the selected output device. You can also specify User Defined sizes.
To Specify a Custom Size
1. Select User defined form the Material list.
2. Enter the size of the media in the boxes immediately below the list.
The Send List
The Send list is where you specify what to do with the design, which is referred to as a job at this
point, once it arrives in the Production Manager.
Send Now
Jobs sent with a Send Now device status are immediately sent to the output device for
cutting.
Hold in List
Jobs sent with a Hold in List device status are sent to Roland CutChoice, but the job will not
be sent to the output device until the user manually sends it.