User`s manual

15
Setup Properties
The Setup Properties dialog can be accessed from within the Cut/Plot dialog or from Roland
CutChoice and defines the settings used to process jobs that do not have properties of their own
associated with them. Setup Properties contain settings for a specific output device. The Setup
Properties dialog contains following three tabs: General, Cut and Communication on Windows
and General, Cut and Ports on Macintosh computers.
The General Tab
Manufacturer
Manufacturer displays the manufacturer of your output device.
Model
Model displays the name and model of your output device.
Setup Name
The setup name displays the name of your output device.
Ports (Windows only)
Selects the port to which the output device is connected. Only change the Port selection if you
physically change the port to which your output device is connected.
Parallel Ports (LPT ports)
The output device should be connected directly to the computer with a Parallel cable.
Note: The USB Port for CX cutters appears as LPT port on Windows 98/ME.