User`s manual

License Agreement
Carefully read the following terms and conditions before installing the software. This is a legal agreement between you,
the end user (either an individual or an entity), and Roland DG Corporation. Use of this program indicates your acceptance
of the terms and conditions stated below.
The enclosed computer program ("Software") is licensed, not sold, to you by Roland DG Corporation, (hereafter referred to as
“Roland”), for use only under the following terms, and “Roland”, reserves any rights not expressly granted to you.
1. License .This Agreement is governed by the laws of Japan, and the parties shall submit to the exclusive jurisdiction of the
Japanese Court. This license allows you to:
(a) Make one copy of the Software in machine readable form; provided that such a copy of the original may be used solely for
backup purposes. As an express condition of this License, you must reproduce on each copy the “Roland”, copyright
notice and any other proprietary legends on the original copy supplied by “Roland”.
(b) Transfer the Software and all rights under this License to another party together with a copy of this License and all written
materials accompanying the Software provided you give “Roland”, written notice of the transfer and the other party reads
and agrees to accept the terms and conditions of this License.
(c) Use this Software on a single computer only, but may transfer it to another computer as long as it is used on only one
computer at a time. "In use" constitutes being loaded onto either temporary (i.e., RAM) or permanent memory (e.g., hard
disk, CD-ROM or other storage device) of a computer.
2. Restrictions .You may NOT distribute copies of the Software to others or electronically transfer the Software from one
computer to another over a network. You may not decompile, reverse engineer, disassemble or otherwise reduce the Software
to a human perceivable form. You may not modify, adapt, transfer, rent, lease, loan, resell for profit, distribute, network or create
derivative works based upon the software or any part thereof.
3. Termination .“Roland” retains the right to terminate this agreement without notice immediately when any of the following
occurs:
(a) When you violate any article of this Agreement.
(b) When you make any serious breach of faith regarding this Agreement.
4. Warranty Disclaimer, Limitation of Remedies and Damages. In no event will “Roland”, be liable for any damages, including
lost data, lost profits, cost of cover or other special, incidental, consequential or indirect damages arising from the use of the
program however caused and on any theory of liability. This limitation will apply even if “Roland”, or an authorized dealer or
distributor has been advised of the possibility of such damage.
“Roland” is not responsible for any typographical errors in the software or in the documentation.
© Copyright 2001 by Scanvec Amiable.
All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any form or by any
means, electronic, mechanical, photocopy, recording or otherwise, without the prior written permission of the publisher.
CutChoice is a trademark of Roland DG Corporation.
Windows is a registered trademark of Microsoft Corporation.
Macintosh is a registered trademark of Apple Computer, Inc.
Other brand names are trademarks or registered trademarks of their respective holders.
R1-010808