User`s manual

5
System Requirements Windows
The following table lists the minimum and recommended system setup to run the Software.
System requirements vary according to the design application you are using, the output device
used, and other variables. Your particular setup and intended use of the software determine what
hardware and software setup you need to get the most out of the Software. If you are working
with relatively small files, the minimum setup may be sufficient. Similarly, if you are working with
large files, you should consider the recommended setup. Consult your dealer for advice when
choosing a system.
Minimum Recommended
Processor Pentium II 233MHz Pentium II 400MHz or faster
RAM 128MB 256MB or more
Install Space 100MB 100MB
Working Disk
Space
1GB 1GB or more for storage
Operating
System(*1)
Running latest version of:
Windows 98/ME/2000
Running latest version of:
Windows98/ME/2000
Video 800 x 600 screen resolution with
16 bit color
800 x 600 screen resolution with
16 bit color
Other 4x CD-ROM Drive 16x CD-ROM Drive
Parallel (*2) ECP Capable (SX only) ECP Capable (SX only)
USB (*3) USB (CX only) USB (CX only)
*1 – This software only supports computer that have these OS factory installed. Computers with
user upgraded OS may not work properly.
*2 – SX cutters should be connected to the computer’s parallel port.
*3 – CX cutters should be connected directly to the USB port.