User`s manual

6
System Requirements Macintosh
The following table lists the minimum and recommended system setup to run the Software.
System requirements vary according to the design application you are using, the output device
used, and other variables. Your particular setup and intended use of the software determine what
hardware and software setup you need to get the most out of the Software. If you are working
with relatively small files, the minimum setup may be sufficient. Similarly, if you are working with
large files, you should consider the recommended setup. Consult your dealer for advice when
choosing a system.
Minimum Recommended
Processor Power PC 166 G3 or G4 300 MHz or faster
RAM 128 MB RAM with virtual
memory enabled (*1)
256MB RAM with virtual
memory enabled (*)
Install Space 100MB 100MB
Working Disk
Space
1GB or more 1GB or more for storage
Operating System Mac OS 8.6 – 9.x with
Appearance Manager
Mac OS 8.6 – 9.x with
Appearance Manager
Video 800 x 600 screen resolution with
16 bit colors
800 x 600 screen resolution with
16 bit colors
Other 4x CD-ROM Drive 16x CD-ROM Drive
USB CX:USB
SX:USB-PIA (*2)
CX:USB
SX:USB-PIA (*2)
*1 – Requires virtual memory enabled. Set to 196-MB minimum.
*2 – SX Cutters should be connected to the computer through the USB to Parallel cable (RCC-
UP3A). CX Cutters should be connected directly to the USB port.