Specifications

24
Dec.2004
10. DSP Thru Waveform check
fig.outputdacheck1.eps
10-1. Check the [MASTER OUTPUT]
waveform.
fig.outputdacheck2.eps
VOLT/DIV:2V TIME/DIV:1mS
10-2. Slowly turn [MASTER VOLUME]
toward the minimum position.
Verify that the square wave shown in the illustration from “OUTPUT L/R”
gradually decreases.
10-3. Slowly turn [MASTER VOLUME]
toward the maximum position.
Verify that the square wave shown in the illustration from “OUTPUT L/R”
gradually increases.
* Note: The waveform must not abruptly increase or cut out.
* Note: Misshapen waveforms or waveforms below the nominal level are NG.
10-4. Disconnect the plug from
[MASTER OUTPUT] R, and check the
waveform.
fig.outputdacheck3.eps
10-5. Insert the plug back into
[MASTER OUTPUT] R, and check the
waveform.
fig.outputdacheck4.eps
10-6. Disconnect the plug from
[MASTER OUTPUT] L (MONO), and
check the waveform.
fig.outputdacheck5.eps
10-7. Insert the plug back into
[MASTER OUTPUT] L (MONO), and
check the waveform.
fig.outputdacheck6.eps