Owner`s manual
Introduction
6
Panel Descriptions
Front Panel
1
2
3 4 5
6
1
INPUT 1, 2 jacks (combo jacks)
XLR connector
(balanced)
Phone type plug
(unbalanced)
TRS phone
type plug
(balanced)
These are analog audio input jacks with microphone preamps.
They accommodate both XLR connectors and 1/4-inch phone
type jacks, and support both balanced and unbalanced
connections.
INPUT 1, 2 jacks Input sensitivity
XLR connector -60– -12 dBu
Phone type plug -46–+2 dBu
MEMO
• To prevent malfunction and equipment failure, always turn down the volume and turn o all
devices (except the computer) before making any connections.
1: GND
2: HOT
3: COLD
GND (SLEEVE)
HOT (TIP)
COLD (RING)
• DUO-CAPTURE EX is equipped
with balanced (XLR/TRS) type
jacks. Wiring diagrams for these
jacks are shown here. Make
connections after rst checking
the wiring diagrams of other
equipment you intend to connect.
• Set the [INST] switch (p. 9) and [PHANTOM] switch (p. 9) as appropriate for the audio device that
is connected.
• Use a microphone with an XLR connector. The sound level will be very low if
you use a microphone with a phone type plug.
• When connecting a guitar or bass, use the INPUT 1 jack. The sound level will
be very low if you connect directly to the INPUT 2 jack.