Owner`s manual

Deutsch Français Italiano Español Português NederlandsEnglishEnglish
°
Message List
Indication Meaning
E.01
The music le you attempted to save is read-only. It cannot be saved.
E.02
An error occurred while writing. It may be that the protect tab of the
external media is in the “Protect (write prohibit)” position, or that the
external media has not been formatted.
E.10
No USB ash drive connected. Connect a USB ash drive and try the
operation again.
E.11
There is insucient free space at the save destination. Either connect a
dierent USB ash drive, or delete unwanted data (song data) and try
the operation again.
E.14
An error occurred while reading. The USB ash drive may be damaged.
Connect a dierent USB ash drive and try the operation again. You may
also format the USB ash drive (p. 7).
E.15
The le could not be read. The data format is not compatible with the
unit.
E.16
The data could not be read fast enough during song playback. After
waiting several seconds, you may be able to play back the song by
pressing the [s] button once again.
E.18
This audio format is not supported. Please use WAV format, 44.1 kHz,
16-bit linear audio les.
E.30
The unit’s internal memory is full.
E.40
The unit cannot deal with the excessive MIDI data sent from the external
USB MIDI.
Reduce the amount of MIDI data sent to the unit.
E.46
The access point is not supported. Please use WPA or WPA2 authentica-
tion.
E.51
There may be a problem with the system.
Repeat the procedure from the beginning. If it is not solved after you
have tried a number of times, contact the Roland service center.
E.65
The USB ash drive connector was subjected to excessive current.
Make sure that there is no problem with the external media, then turn
the power o, then on again.
- - -
The Panel Lock function is on (p. 9).
PU
When playing back a song, this is shown if the song starts on an upbeat.
Blinking
number
When the Auto O function is activated, the remaining time blinks
before the power turns o.
17