Owner`s manual

You can record your performance, including accompaniment.
You can play back a recorded performance to check your playing, or to play along with
it.
Getting Ready to Record
1. Select the tone that you want to play on the keyboard (p. 2).
2. Start the metronome if desired.
Press the [Metronome] button.
While the metronome is sounding, specify the tempo and time signature of
the song (p. 3).
If you want rhythm to play
3. If you want a rhythm accompaniment to be heard while you
perform, press the [Rhythm] button.
Specify the rhythm and tempo settings (p. 5).
If you don't want rhythm to play
3. Press the [Song] button so the button is lit.
Entering Recording-standby Mode
4. Hold down the [Song] button and press the [Rhythm] button.
The [Song] button and the [Rhythm] button will light; the unit will enter
recording-standby mode.
MEMO
If you decide not to record (i.e., if you want to exit recording-standby
mode), hold down the [Song] button once again and press the [Rhythm]
button.
Starting Recording
5. Press the [s] button.
A two-measure count will sound, and then recording will start.
During the count, measure numbers “
-2
” and then “
-1
” will appear in the
display.
MEMO
Recording will start automatically if you play the keyboard while in
recording-standby mode.
Stopping Recording
6. Press the [s] button.
By pressing the [s] button once again, you can hear the song that you
just recorded.
Selecting the Destination of the Save
7. Use the [-] [+] buttons to select the destination at which to save,
and then press the [Metronome] button.
U
(User)
U.01
–
U.10
N
(USB)
N.01
–
N.gg
v01
A song with no recorded data (empty song)
• Song number shown with lowercase “
v
” (User memory)
• Song number shown with lowercase “
n
” (USB ash drive)
• No dot shown
U.01
A song with recorded data
• Song number shown with uppercase “
U
” (User memory)
• Song number shown with uppercase “
N
”
(USB ash drive)
• Dot shown
MEMO
If you decide not to carry out the save, hold down the [Song] button and
press the [Rhythm] button to cancel it.
NOTE
If you select a song that already contains data (song number with an
uppercase “
U
” or “
N
”) and save, the previously recorded data will be
lost.
* While the song is being saved, an animation of a rotating “
o
” symbol
will appear in the display for several seconds. Do not turn o the
power during this time. Doing so might cause the saved song to
be lost.
Recording Performances
If you want to erase the recorded song
You can erase a song by recording an empty song as follows.
1. Press the [Song] button.
2. Hold down the [Song] button and press the [Rhythm] button.
3. Press the [s] button to hear the two-measure count, and then press the [s] button without playing the keyboard.
4. Select the song number that you want to erase, and press the [Metronome] button.
A song containing no notes will be recorded; the song has been erased.
Operation Guide
6