User Manual

Panel Descriptions
Introduction Playing/Creating Sounds Use with a Computer Overall Settings Appendix
Quick Guide
Playing the Demo Song
1. Press the [MENU] button.
2. Choose “DEMO PLAY” and press the [ENTER] button.
3. Choose a demo song and press the [ENTER] button.
The demo song will play.
* The performance data for the demo song will not be output from the MIDI OUT connector.
* If you want sound to be produced from the front center / subwoofer of your 5.1 channel speaker system, turn the 5.1CH Center SP Switch /
Sub Woofer(LFE) Switch “ON.”
MEMO
The DEMO MENU screen can also be accessed by pressing the [EXIT] button while holding down the [SHIFT] button.
Turning the INTEGRA-7 On/O
Once everything is properly connected (p. 22), be sure to follow the procedure below to turn on their power. If you turn on equipment in the wrong
order, you risk causing malfunction or equipment failure.
Turning the INTEGRA-7 On
Before turning the unit on/o, always be sure to turn the volume down. Even with the volume turned down, you might hear some sound when
switching the unit on/o. However, this is normal and does not indicate a malfunction.
1. Minimize the volume of the INTEGRA-7 and your speakers.
2. Turn the INTEGRA-7’s [ ] switch ON.
This unit is equipped with a protection circuit. A brief interval (a few
seconds) after turning the unit on is required before it will operate
normally.
3. Turn on the power of your speakers.
4. Use the [VOLUME] knob to adjust the volume
appropriately.
NOTE
With the factory settings, the INTEGRA-7 will
automatically be switched o four hours after you
stop playing or operating the unit. If you don’t want
the unit to turn o automatically, change the “Auto O” setting
to “OFF” as described on p. 55.
* The settings you were editing will be lost when the unit is
turned o. If you want to keep your settings, you must save your
settings before turning the unit o.
* When turning the unit back on after it was turned o by the
Auto-O function, you must wait at least 10 seconds before
turning the unit on. If you do not allow this interval to pass, the
Auto-O function might not be reset, and the unit might not
turn on normally.
Turning the INTEGRA-7 O
1. Minimize the volume of the INTEGRA-7 and your speakers.
2. Turn o the power of your speakers.
3. Turn the INTEGRA-7’s [ ] switch OFF.
NOTE
If you need to turn o the power completely, rst turn o the
unit, then unplug the power cord from the power outlet. Refer
to Power Supply (p. 5).
21