User Manual

Using the INTEGRA-7 with Your Computer
USB AUDIO
Sound played back by your computer can be output from the INTEGRA-7.
MEMO
If you want to use the INTEGRA-7’s USB audio functionality, change the USB Driver setting to VENDER and then install the driver. You can download
the driver from the Roland website.
Roland website
http://www.roland.com/support/en/
The procedure for installing the driver will dier depending on your system. Before you proceed, you should carefully read the “Readme” le that
was extracted along with the installer.
Audio Signal Flow
5.1 CH L
2 CH L
5.1 CH R
2 CH R
5.1 CH C
5.1 CH Ls
5.1 CH Rs
5.1 CH LFE
B-L (3)
A (MIX)-L (1)
USB OUTPUT L
B-R (4)
A (MIX)-R (2)
USB OUTPUT R
C-L (5)
C-R (6)
D-L (7)
D-R (8)
USB INPUT L
USB INPUT R
Front INPUT L
Front INPUT R
Rear INPUT L
Rear INPUT R
Sound Generator
Part 1–16
INTEGRA-7
Chorus
Motional
Surround
Reverb
or
Computer
USB
Ext Part Source
Select (p. 48)
Specifying the Sampling Rate for USB Audio
Here’s how to specify the sampling rate of the INTEGRA-7. If you’re using software, you’ll also need to restart your software.
The USB Audio Sampling Rate must be set to match the sampling rate of the software you’re using.
1. In the MENU screen, choose “SYSTEM” and press the [ENTER] button.
2. In the “SOUND” tab, choose “Sampling Rate” and change the setting.
3. Change the “Sampling Rate” setting.
MEMO
If you want to save the setting, hold down the [SHIFT] button in the system setting screen and press the [EDIT] button.
The INTEGRA-7’s audio format
Sampling rate 44.1, 48, 96 kHz
Bit depth 24-bit (xed)
Number of channels 2 channels (stereo)
46