User Manual

Convenient Functions
Introduction Playing/Creating Sounds Use with a Computer Overall Settings Appendix
Quick Guide
Restoring the Factory Settings
(FACTORY RESET)
This “FACTORY RESET” operation will restore all settings of the
INTEGRA-7 to their factory-set state.
NOTE
When you execute the Factory Reset operation, all data in the
INTEGRA-7 will be lost. If there is any data that you want to keep,
back it up to a USB ash drive (p. 52).
1. In the MENU screen, choose “UTILITY” and press the
[ENTER] button.
The UTILITY screen will appear.
2. Choose “FACTORY RESET” and press the [ENTER] button.
3. To execute the factory reset, choose “OK” and press the
[ENTER] button.
NOTE
Never turn o the unit before the factory reset has been
completed.
4. Turn the INTEGRA-7 o, and then on again.
Making the Unit Automatically Turn
O After a Time (Auto O)
With the factory settings, the INTEGRA-7 will automatically be
switched o 4 hours after you stop playing or operating the unit.
If you don’t need the unit to turn o automatically, set “Auto O” to
the “OFF” setting as described below.
1. In the MENU screen, choose “SYSTEM” and press the
[ENTER] button.
The SYSTEM screen will appear.
2. Use the cursor [ ] [ ] buttons to select the “SETUP” tab.
3. Use the cursor [ ] [ ] buttons to select “Auto O,” and
change the setting.
Value Value
OFF The unit will not turn o automatically.
30 [min]
The unit will automatically turn o if no operation is
performed for 30 minutes.
240 [min]
(default)
The unit will automatically turn o if no operation is
performed for 240 minutes (4 hours).
4. Hold down the [SHIFT] button and press the [EDIT]
button.
A message will indicate “Completed!” and the settings will be saved.
NOTE
• Never turn o the unit while data is being saved.
• When turning the unit back on after it has been shut down due
to the Auto O function, always make sure to allow at least ten
seconds to pass after the unit has been shut o before you turn
the unit back on. If you turn it back on too rapidly, the Auto O
function will not have had enough time to reset itself, and you
may not be able to turn on the unit in the normal way.
55