Owner`s manual

107
Chapter 6 Making Original Patches
Chapter6
P-ENV: VELO TIME SENS (VELOCITY TIME
SENSE)
This parameter lets your playing velocity the overall time of
the entire Pitch Envelope.
With positive (+) settings, TIME1 will become faster as you
play the keyboard more strongly. With negative (-) settings,
time will become slower as you play the keyboard more
strongly.
When Velocity TIME Sensitivity is set to a positive value, the
pitch will change slowly for softly-played notes, and rapidly
for strongly-played notes.
Range: -100– +100
P-ENV: TIME1–4 (ENVELOPE TIME1–4)
TIME1–4 (Pitch Envelope TIME 1–4)
Specifies the time until the next pitch level is reached. You
can make settings for the four parameters TIME 1–4.
Higher settings will result in a longer time until the next
pitch level is reached.
Range: 0–127
P-ENV: LEVEL1–4 (ENVELOPE LEVEL1–4)
Level1–4 (Pitch Envelope Level 1–4)
Specifies the pitch difference relative to the normal pitch (as
specified by Coarse Tune and Fine Tune). You can make
settings for the four parameters, Level 1–4.
Positive (+) settings will raise the pitch above the normal
pitch. Negative (-) settings will lower the pitch below the
normal pitch.
Range: -63– +63
Changing the Brightness of
Sounds (FILTER and ENVELOPE)
FLTE” lets you make settings that affect the brightness of the
percussion instrument sounds.
“F-ENV:” is used to define parameters concerning changes in
the brightness of the sound relative to time.
Procedure
1. Press the [PTN] button.
2. Press [PART SELECT] then, Press [R] part buttons to
select the part R.
3. Press [F1 (PACH)] and [F1 (EDIT)] button, in that order.
4. The menu screen for rhythm set editing appears.
5. Press the [CURSOR (up)] button.
6. Press the [F3 (FLTR)] button.
7. To edit parameters in the “FILTER:”, press [F1 (FLTR)]
button. To edit parameters in the “F-ENV:”, press [F2
(FENV)] button.
One of the editing screens appears.
8. Press the [F3 ( )]/[F4 ( )] buttons to select the
parameter to be edited.
9. Press an appropriate keyboard pad to select the key for
which you want to define the parameter.(You can listen
to the sound to confirm which tone is selected.)
10.Specify a value using the [VALUE] dial or the [INC/
DEC] buttons.
11.After the value is specified, press the [EXIT] button to
return to the previous screen.
Parameters that can be set
- FILTER:
TYPE, CUTOFF, RESONANCE, RES VELO SENS
- F-ENV:
ENV DEPTH, VELO SENS, VELO TIME SENS, TIME1–
4, LEVEL1–4
* See the following sections for descriptions of the setting ranges
and contents of the respective parameters.
+
0
-
Time1(A) Time2
Level1 Level3(S)
Level2 Level4
Time3(D) Time4(R)
Pitch
Time
Key On Key Off