Owner`s manual

114
Chapter 7 Environment Configuration and Application with MIDI
Saving system settings
There are two types of system settings: those that are
preserved when the power is turned off (backup
parameters), and those that return to their default settings
when the power is turned off.
Backup parameters are saved when you press the [EXIT]
button to close the setting screen. (At this time, the display
will indicate “NOW WRITING...”)
Configuration (System)
Here you can make settings that affect the operation of the
entire MC-307, such as tuning and the synchronization
method.
* It is not possible to enter these set-up screens while a pattern
or song is being played back.
Tuning and Sound Generator
Related Settings
Setting effects on/off (EFFECT SW)
This switch is used to activate/deactivate the effects. The
reverb, delay and Multi effects (M-FX) effects can be set on/
off individually.
Procedure
1. Press the [SYSTEM] button, then the [F1 (SYS)] button.
The selection screen for system settings appears.
2. Press the [CURSOR (up)] button to access the screen for
items 1–4.
3. Press the [F1 (SND)] button.
One of the “SYSTEM: SOUND” set-up screen appears.
4. Press [F1 (SND)] button.
If the following screen is not displayed, use [F3 ( )][F4
( )] to make it appear.
5. Use the [CURSDOR (up/down)] buttons to move the
cursor to “REVERB,” “DELAY” or “M-FX.”
6. Set up a value using the [VALUE] dial or the [INC/DEC]
buttons.
Range: OFF, ON
Parameter Type: Returns to "ON" each time you turn off the
power
Specifying how patches will be
switched (PATCH REMAIN)
This specifies whether the sound that was being heard at the
moment you switched patches or rhythm sets will continue
sounding, or whether it will stop.
If this is turned ON, the previous sound will continue. If this
is OFF, the sound will stop.
Procedure
1. Press the [SYSTEM] button, then the [F1 (SYS)] button.
The selection screen for system settings appears.
2. Press the [CURSOR (up)] button to access the screen for
items 1–4.
3. Press the [F1 (SND)] button.
One of the “SYSTEM: SOUND” set-up screen appears.
4. Press [F1 (SND)] button.
If the following screen is not displayed, use [F3 ( )][F4
( )] to make it appear.
5. Use the [CURSOR (up/down)] buttons to move the
cursor to “PATCH REMAIN.”
6. Specify a value using the [VALUE] dial or the [INC/
DEC] buttons.
Range: OFF, ON
Parameter Type: Backup parameters
Sound
Generater
OUTPUT jack
SYSTEM: SOUND
REVERB SW
DELAY SW
M-FX SW
SYSTEM: GRAB
REVERB
DELAY
M-FX
GRAB SW