Owner`s manual

115
Chapter 7 Environment Configuration and
Chapter7
Specifying the number of notes for
each part (VOICE RESERVE)
Specifies the number of notes that will be reserved for each
part when the total number of requested notes exceeds
64.Voice Reserve settings can be made up to a total of 64
notes for all parts.
Procedure
1. Press the [SYSTEM] button, then the [F1 (SYS)] button.
The selection screen for system settings appears.
2. Press the [CURSOR (up)] button to access the screen for
items 1–4.
3. Press the [F1 (SND)] button.
One of the “SYSTEM: SOUND” set-up screen appears.
4. Press the [F1 (SND)] button.
If the following screen is not displayed, use [F3 ( )][F4
( )] to make it appear.
5. Use the [CURSOR (up/down)] buttons to move the
cursor to “VOISE RESERVE P - *.”
( * = Part Name)
Select the destination part.
6. Press the [PART SELECT] button.
7. Press the part button, [R], [1] to [7], for the part for which
the parameter is to be set up.
The number of the pressed part button is displayed after
“P-.”
8. Specify a value using the [VALUE] dial or the [INC/
DEC] buttons.
Range: 0–64
Parameter Type: Backup parameters
Defining the variable range for
resonance (RESONANCE LIMITER)
You can specify the range in which the [RESONANCE] knob
can be adjusted.You can make separate settings for the
rhythm part [RESONANCE LIMIT R] and for the other parts
[RESONANCE LIMIT N].
As this setting is increased, the variable range of the
[RESONANCE] knob will increase.
Procedure
1. Press the [SYSTEM] button, then the [F1 (SYS)] button.
The selection screen for system settings appears.
2. Press the [CURSOR (up)] button to access the screen for
items 1–4.
3. Press the [F1 (SND)] button.
One of the “SYSTEM: SOUND” set-up screen appears.
4. Press the [F1 (SND)] button.
If the following screen is not displayed, use [F3 ( )][F4
( )] to make it appear.
5. Use the [CURSOR (up/down)] buttons to move the
cursor to “RESONANCE LIMIT R” or “RESONANCE
LIMIT N.”“R” is to set up the parameter for the rhythm
part and “N” is for one of Parts 1 to 7.
6. Specify a value using the [VALUE] dial or the [INC/
DEC] buttons.
Range: 50 – 127
Parameter Type: Backup parameters
Tuning the entire system
(MASTER TUNE)
This adjusts the tuning of the MC-307’s sound generator. The
display shows the frequency of the A4 note.
Procedure
1. Press the [SYSTEM] button, then the [F1 (SYS)] button.
The selection screen for system settings appears.
2. Press the [CURSOR (up)] button to access the screen for
items 1–4.
3. Press the [F1 (SND)] button.
One of the “SYSTEM: SOUND” set-up screen appears.
4. Press [F1 (SND)] button.
5. Use the [CURSOR (up/down)] buttons to move the
cursor to “MASTER TUNE.”
6. Specify a value using the [VALUE] dial or the [INC/
DEC] buttons.
Range: 427.4 – 440.0 – 452.6 (Hz)
Parameter Type: Backup parameters