Owner`s manual

120
Chapter 7 Environment Configuration and
indicator will light.
Parameter Type: Backup parameters
Transmitting synchronization
messages (SYNC OUT)
This specifies whether or not synchronization-related MIDI
messages will be transmitted.
When this is on, the following messages will be transmitted
from the MIDI OUT connector.
Procedure
1. Press the [SYSTEM] button, then the [F1 (SYS)] button.
The selection screen for system settings appears.
2. Press the [CURSOR (up)] button to access the screen for
items 1–4.
3. Press the [F3 (SEQ)] button.
One of the “SYSTEM: SEQ” screens appears.
4. Press the [F2 (PRM2)] button.
5. Use the [CURSOR (up/down)] buttons to move the
cursor to “SYNC OUT.”
6. Specify a value using the [VALUE] dial or the [INC/
DEC] buttons.
Range: OFF, ON
- Timing Clock:F8
- Start: FA
- Continue:FB
- Stop: FC
- Song Position Pointer:F2
Parameter Type: Backup parameters
Synchronizing arpeggios to the
pattern (ARPEGGIO SYNC)
You can specify whether or not arpeggios will be
synchronized to the pattern playback. If you do not want
arpeggios to be synchronized to the pattern playback, turn
Arpeggio Sync “OFF.”
Procedure
1. Press the [SYSTEM] button, then the [F1 (SYS)] button.
The selection screen for system settings appears.
2. Press the [CURSOR (up)] button to access the screen for
items 1–4.
3. Press the [F3 (SEQ)] button.
One of the SYSTEM: SEQ set-up screens appears.
4. Press the [F2 (PRM2)] button.
5. Use the [CURSOR (up/down)] buttons to move the
cursor to “ARPEGGIO SYNC.”
6. Specify a value using the [VALUE] dial or the [INC/
DEC] buttons.
Range: OFF, ON
Parameter Type: Backup parameters
Making songs play continuously
(SONG LOOP MODE)
This specifies how songs will be played back.
You can cause the same song to be played back repeatedly, or
all songs to be played back in sequence.
Procedure
1. Press the [SYSTEM] button, then the [F1 (SYS)] button.
The selection screen for system settings appears.
2. Press the [CURSOR (up)] button to access the screen for
items 1–4.
3. Press the [F3 (SEQ)] button.
One of the SYSTEM: SEQ set-up screens appears.
4. Press the [F3 (PRM3)] button.
5. Use the [CURSOR (up/down)] buttons to move the
cursor to “SONG LOOP MODE.”
6. Specify a value using the [VALUE] dial or the [INC/
DEC] buttons.
Available Settings:
- OFF:
This is the normal condition. The currently selected song
will be played back only once.
- LOOP 1:
The currently selected song will be played back
repeatedly.
- LOOP 2:
All songs will be played back repeatedly in sequence.