Owner`s manual

16
Chapter 1 Introducing the MC-307
Metronome Settings
The metronome can be set to automatic on/off according to
the operating mode of the MC-307.
Procedure (Pattern/Song play screen)
1. Press [PTN] (or [SONG]) button.
2. Press [F4 (BPM)] button.
3. Press [CURSOR (up/down)] buttons to move the cursor
over to “METRO NOME.”
4. Set up the mode using [VALUE] button dial or [INC/
DEC] buttons.
Procedure (Realtime Recording screen)
1. Press [PTN] button.
2. Press [REC] button.
3. Press [F2 (REALTIME)] button.
4. Press [PLAY] button.
Realtime Recording starts.
5. Press [F4 (BPM)] button.
6. [CURSOR (Up/Down)] button to move cursor over to
“METRONOME.“
7. Set up the mode using [VALUE] button dial or [INC/
DEC] buttons.
Available Settings
- OFF: The metronome does not play, regardless
of the operation of the MC-307.
- ON: The metronome plays, regardless of the
operation of the MC-307.
- REC ONLY: The metronome plays only during
recording.
- PLAY&REC: Sounds during playback and recording.
*
You can also set the volume of the metronome. For the
procedure, refer to Setting up the volume level of the
metronome (METRONOME LEVEL) (p. 119).
Restoring the Factory
Settings (FACTORY RESET)
This operation can restore the settings of the MC-307 to their
factory settings.
Procedure
1. Press [SYSTEM] button.
The menu screen for system set-up appears.
2. Press [F2 (UTIL)] button.
3. Press [CURSOR (down)] button.
Go to the screen where “FACTORY RESET” appears.
4. Press [F1 (FACT)] button.
The “FACTORY RESET” screen appears and an “ARE
YOU SURE?” message appears.
5. Press [F4 (EXEC)] button to execute factory reset.
After 6 minutes, factory reset is completed and the
“COMPLETED!” message appears.
After a short while, the screen displayed immediately after
startup appears.
When Factory Reset is executed, the data in the MC-307’s
memory is lost. If there is any data in the MC-307 that you
do not want to delete, use the Bulk Dump operation (P. 129)
to save the data to an external MIDI sequencer or similar
device.