Owner`s manual

29
Chapter 3 Giving Variation to Pattern
Chapter3
* In TR-REC (P. 68) and “Changing the Settings for Each
Part” (P. 22), the above assignments cannot be used (the
assignable knobs have other special functions when used for
TR-REC and Part settings).
* The assignable knobs can be used for user-defined settings
while the arrow shown in the figure below is lit. For user-
defined settings, desired parameters can be assigned to the
knobs, allowing operation with the knobs. For details, see
“Assigning and using desired parameters” described in the
next section.
Assigning and using desired
parameters
It is also possible to assign and use other parameters to
assignable knobs as you desire.
Procedure
1. Press the button to the left of the assignable knobs, then
select a user (one of the indicators above the knobs comes
on.)
2. Press [KNOB ASSIGN] button.
The “KNOB ASSIGN” screen appears.
3. Rotate the [VALUE] dial or press [INC/DEC] to select
the User set to which the settings are to be assigned.
4. For the selected User set, the functions currently
assigned to each knob will be shown.
5. Press the F1 - F4 button above the knob to be set up.
The “KNOB 1 (2 - 4)ASSIGN PARAM” screen appears.
6. Select a group of functions to be assigned using the
[VALUE] dial or the [INC/DEC] buttons.
7. Press [ENTER] button. Or, press the [F] button below the
group name.
The parameters for that function group are displayed.
For details of the groups that can be selected, see “Range
of settings” at the end of this section.
8. Select a parameter using the [VALUE] dial or the [INC/
DEC] buttons, then press [ENTER] button.
The function of the selected parameter is assigned to the
knob.
You can work on the parameter by operating the knob.
Range of settings:
Groups that can be selected in step 5 and parameters that can
be selected in step 5.
STUP (SETUP
) Group
• LV (LEVEL)
• PAN (PAN)
• KSFT (KEY SHIFT)
• R-LV (REVERB LEVEL)
• D-LV (DELAY LEVEL)
• FXSW (M-FX SW)
REV (REVERB
) Group
• TYPE (TYPE)
• TIME (TIME)
• HF (HF DAMP)
• FX->R(M-FX TO REV LEVEL)
• R-LV (REVERB LEVEL)
DLY (DELAY
) Group
• TYPE (TYPE)
• TIME (TIME)
• FB (FEEDBACK)
• HF (HF DAMP)
• OUT (OUTPUT)
• FX->D(M-FX TO DLY LEVEL)
• D-LV (DELAY LEVEL)
M-FX (MULTI-FX) Group:
• C1 - C11 (CONTROL 1 - 11)
Parameters for C1-C11 of M-FX will differ depending on
the selected multi-effect. For details on the parameters,
refer to P. 45.
ARP (ARPEGGIO) Group:
• STYL (STYLE)
• MTIF (MOTIF)
• PTN (BEAT PATTERN)
• SHUF (SHUFFLE RATE)
• ACNT (ACCENT RATE)
• OCT (OCTAVE RANGE)
QTZ
(QUANTIZE) Group:
• TYPE (TYPE)
• TMPL (TEMPLATE)
• TIME (TIMING)