Owner`s manual

2. Before you start recording, set the record-
ing parameters.
There are five recording parameters, as described
below. Use PAGE [<] [>] to select a parameter, and use
[INC] [DEC] or the [VALUE] dial to set the value.
Beat
Specifies the time signature of the pattern to be newly
recorded.
Range: 2/4Ð7/4, 5/8Ð7/8, 9/8, 12/8, 9/16, 11/16, 13/16,
15/16, 17/16, 19/16
PTN Length (Pattern Length)
Specifies the length of the pattern to be newly record-
ed.
Range: 1Ð32 measures
Count In
Specifies how recording will begin.
Range:
COUNT 0: Recording will begin the instant you
press [PLAY].
COUNT 1, 2: A count-in of one measure (or two
measures) will sound when you
press[PLAY], and recording will begin
when the count-in ends.
WAIT NOTE: Recording will begin when you press a
keyboard pad or the hold pedal.
Loop Rest
Turn this on if you want to record smoothly across the
boundary of a pattern.
Range: OFF, ON
For details on using Loop Rest...
☞ ÒRecording Smoothly Across Pattern
BoundariesÓ (p. 131)
Input QTZ (Input Quantize)
By using Input Quantize you can correct the timing of
the notes you play as they are recorded.
Range: OFF,
Set this to the shortest note value that will occur in the
phrase you wish to record.
At this time, you can use the [TIMING] knob to speci-
fy the Strength value.
When this setting is ÒOFF,Ó the notes will be recorded
at the timing that you play them.
* It is not possible to modify the Beat of a pattern that has
already been recorded. Nor is it possible to shorten the
Pattern Length. If you wish to modify these values, use
the Pattern Initialize (p. 27) operation to clear the con-
tents of the pattern before you make settings.
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
About the metronome
If you wish to record along with the metronome, press
[METRONOME] to turn on the metronome. Press
[METRONOME] once again to turn it off.
Even in cases other than real-time recording, you can
press [METRONOME] to switch the metronome on or
off.
fig.10-6
Adjusting the metronome volume...
☞ Adjusting the Metronome Volume
(Metronome Level)Ó (p. 166)
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
3. Select the part that you wish to record by
pressing the PART button for that part.
This will select the part that will be recorded (the
Recording Part).
The indicator of the button you pressed will light.
fig.10-7
4. When preparations are complete, you can
start recording with the selected recording
method. Recording can be started in one of
the following two ways.
REC
PAGE
Chapter 10. Recording Patterns
128
0