Owner`s manual

2. Hold down [EDIT] and press keyboard pad
[3].
The Delete Measure setting page will appear.
fig.11-16
3. Select the part from which you wish to
delete data.
* You can select more than one part.
4. Specify the measure at which deletion will
begin.
Range: 1Ð32
5. Press [ENTER].
The cursor will move to the right.
6. Specify the measure length (number of
measures) that will be deleted.
Range: 1Ð32, ALL
* If the setting is ÒALL,Ó the measure at which deletion began
and all subsequent measures will be affected by the operation.
For example, if you wish to delete from measure 4 to
the end of measure 6, make settings as follows.
fig.11-17
7. Press [ENTER].
The confirmation screen will appear in the display.
fig.11-18
8. Press [ENTER] once again.
The Delete Measure operation will be carried out, and
the normal display will reappear.
Inserting Blank Measures
(Insert Measure)
This operation inserts blank measures into the speci-
fied location of a pattern. If you wish to add more
musical material in the middle of a pattern, use this
operation to insert blank measures before recording
the additional material.
The inserted measures will have the same time signa-
ture as the pattern.
fig.11-19TEXT
* It is not possible to make settings that would make the
pattern length exceed 32 measures.
1. Select the pattern into which measures will
be inserted.
2. Hold down [EDIT] and press keyboard pad
[4].
The display will show the Insert Measure setting page.
fig.11-20
3. Select the part into which you wish to
insert measures.
* You may select more than one part.
4. Specify the measure at which the blank
measures will be inserted.
Range: 0Ð31, END
* If you specify ÒEND,Ó the blank measures will be added to
the end of the musical data.
5. Press [ENTER].
The cursor will move to the right.
6. Specify the measure length (number of
measures) that will be inserted.
Range: 0Ð31
For example, if you wish to insert two blank measures
between measures 3 and 4, make the following settings.
fig.11-21
7. Press [ENTER].
The confirmation screen will appear in the display.
fig.11-22
8. Press [ENTER] once again.
The Insert Measure operation will be carried out, and
the normal display will reappear.
REALTIME ERASE
EDIT
4
1
2
3
4
5
4
5
1
2
3
Insert two blank measures
in measure 4
REALTIME ERASE
EDIT
3
Chapter 11. Editing Patterns (Pattern Edit)
149
11