Owner`s manual

Using Play Quantize Settings
to Modify a Pattern
(Edit Quantize)
You can modify the musical data of a pattern accord-
ing to the Play Quantize settings.
Normally, Play Quantize does not affect the contents
of the musical data, but only modifies the timing at
which the pattern is played back. By using Edit
Quantize, you can modify the musical data itself, so
the data will play back with the same groove even if
you do not apply Play Quantize.
* It is not possible to specify the area of measures in which
the musical data will be modified.
1. Select the pattern whose data you wish to
modify.
2. Play back the pattern, apply Play
Quantize, and adjust the groove as
desired.
3. Press [STOP] to stop the pattern.
4. Hold down [EDIT] and press keyboard pad
[10].
The Edit Quantize setting page will appear in the display.
fig.11-40
5. Select the part (s) for which you wish to
carry out Edit Quantize.
* You may select more than one part.
* The indicators will already be lit for the parts to which Play
Quantize had been applied (the parts selected by [QUAN-
TIZE SELECT]). If you wish to apply the operation to
these same parts, you may simply continue to the next step.
6. Press [ENTER].
The confirmation screen will appear in the display.
fig.41
7. Press [ENTER] once again.
The Edit Quantize operation will be carried out, and
the normal display will reappear. When the operation
is completed, Play Quantize will automatically be
turned off.
Converting the Note Timing
of a Pattern (Reclock)
You can double or halve the timing of the musical data
recorded in a pattern. For example, you can convert a
four-measure pattern of tempo=120 to two measures
so it will play back identically at a tempo of 60. When
you wish to connect patterns of radically differing
tempo, it is a good idea to use the Reclock operation to
match the timing values of the two patterns.
fig.11-42
* Executing the Reclock operation will not affect the origi-
nal tempo of the pattern.
1. Select the pattern whose timing values you
wish to convert.
2. Hold down [EDIT] and press keyboard pad
[11].
The Reclock setting page will appear in the display.
fig.11-43
3. Select the part whose timing values you
wish to convert.
* You may select more than one part.
4. Specify how the timing values will be con-
verted.
Range:
HALF: Timing values will be halved
DOUBLE: Timing values will be doubled
* It will not be possible to make parameter settings for
which the Reclock operation would make the length of the
pattern exceed 32 measures or be shorter than 1 measure.
fig.11-44
5. Press [ENTER].
The Reclock operation will be carried out, and the nor-
mal display will reappear.
REALTIME ERASE
EDIT
11
HALF
DOUBLE
REALTIME ERASE
EDIT
10
Chapter 11. Editing Patterns (Pattern Edit)
153
11