Owner`s manual

Adjusting the Velocity Produced
by Playing the Keyboard Pads
(Pad Velocity)
When you use the keyboard pads to play, all notes
will be sounded with the same velocity (strength).
This setting specifies the velocity that will be used.
Range: 1Ð127
As this value is increased, notes played from the key-
board pad will be stronger.
Specifying How the Pedal Will
Function
Pdl Assign (Pedal Assign)
This specifies the function of a pedal switch connected
to the PEDAL jack.
Range:
HOLD: The pedal will act as a Hold Pedal.
SHIFT: The pedal will act like the SHIFT button.
FUNC: The pedal will act like the FUNC button.
PTN-I: (Pattern Increment) The patterns of the cur-
rently selected pattern set will be successively
selected as the next pattern.
TAP: The pedal will act like the TAP button.
R-TPS: The pedal will act like the TRANSPOSE but-
ton.
PLAY: The pedal will act like the PLAY button /
STOP button.
BEAM: The pedal will switch the DBeam controller
on/off.
SOSTE: The pedal will act as a Sostenuto Pedal.
Pdl Pola (Pedal Polarity)
Select the polarity of the pedal.
Range: STANDARD, REVERSE
If you are using a pedal with inverted polarity (so the
pedal functions in a way opposite from what you
expect), select ÒREVERSE.Ó
Specifying How the DBeam
Controller Will Function
BeamPol (Beam Polarity)
Switch the polarity of the DBeam controller.
Range of settings: STANDARD, REVERSE
With a setting of ÒREVERSE,Ó the direction of control
for the DBeam controller will be inverted.
Beam Assign1 (Beam Assign 1)
Specify the style that will be selected when [TYPE
SELECT] is used to make the top indicator light.
Range of settings: 01Ð28 (Type Number)
With the factory settings, Ò24Ó (24: Turntable) is select-
ed.
Beam Assign2 (Beam Assign 2)
Specify the style that will be selected when [TYPE
SELECT] is used to make the middle indicator light.
Range of settings: 01Ð28 (Type Number)
With the factory settings, Ò07Ó (07: Cut+Reso2-A) is
selected.
Beam Assign3 (Beam Assign 3)
Specify the style that will be selected when [TYPE
SELECT] is used to make the bottom indicator light.
Range of settings: 01Ð28 (Type Number)
With the factory settings, Ò27Ó (27: Adlib1) is selected.
Beam Range L (Beam Range Lower)
Specify the lower limit of the range of the DBeam con-
troller.
Values below this setting will not be output.
Range of settings: 0ÐUPR
Beam Range U (Beam Range Upper)
Specify the upper limit of the range of the DBeam con-
troller.
Values above this setting will not be output.
Range of settings: LWRÐ127
* It is not possible to set the Lower value above the Upper,
nor the Upper value below the Lower. Also, the Beam
Range Lower/Upper settings are valid only when the
selected type is Ò05:Cut+Reso1-AÓÐÓ10:Cut+Reso3-SÓ.
165
Chapter 15. Configuration (System)
15