Owner`s manual
If you are playing the keyboard pads to hear the sound as you edit it, it is best to leave the Octave Shift setting at
Ò0.Ó
SOLO
0
AMPLIFIER
OFF
PITCH-LFO 1
LFO 1
SELECT
SELECT
SELECT
PITCH
DEPTH
PITCH-ENVELOPE
R
SA
DEPTH
D
PORTAMENTO
TIME
TONE1
ON
WAVEFORM
ON
TONE LEVEL
TONE PANFINE TUNE
TONE2
ON
0
FINE TUNE
FILTER-LFO 1
DEPTH
FILTER-ENVELOPE
R
SA
DEPTH
D
AMP-LFO 1
DEPTH
AMP-ENVELOPE
R
SAD
FILTER
AMP
0
FILTER
CUTOFF
LPF
BPF
HPF
PKG
RESONANCE
WAVE
PITCH
SELECT
COARSE TUNE
FILTER
TYPE
RND PAN
RATE
A016
6
5
3
4
7
8
9
2
180
Chapter 16. Advanced Applications
6
1. Execute the Patch Initialize operation to set
the patch to the standard settings (the
Initial Patch) (p. 62).
2. Turn on TONE1 and TONE2. (Hereafter, set
TONE1 and TONE2 to the same settings
unless otherwise specified.)
3. Use [WAVE SELECT] to select the A016
waveform.
4. Rotate the TONE2 [FINE TUNE] knob to the
position (-2) shown in the diagram.
The pitch of the two tones will be skewed slightly, cre-
ating a rich sound.
5. As desired, you can rotate the [RESONANCE]
knob to add character to the sound (50).
6. Move the A-ENV section [R] slider to the
position (10) shown in the diagram.
A decay will remain after you release the key.
7. Press [SOLO] to turn on the Solo switch.
Now you will be able to play single notes.
8. Press PORTAMENTO [ON] to turn on
Portamento.
9. Rotate the [TIME] knob to the position (10)
shown in the diagram to adjust the amount
of portamento.
As an effect, you may wish to apply a light delay. It
will also be interesting to use EFX to apply some light
flanging.