Owner`s manual
Synth Bass
LetÕs create a synth bass sound using a distorted square waveform.
fig.17-21
If you will be playing the keyboard pads to hear the sound as you edit, set Octave Shift to Ò-2.Ó
SOLO
0
AMPLIFIER
OFF
PITCH-LFO 1
LFO 1
SELECT
SELECT
SELECT
PITCH
DEPTH
PITCH-ENVELOPE
R
SA
DEPTH
D
PORTAMENTO
TIME
TONE1
ON
WAVEFORM
ON
TONE LEVEL
TONE PANFINE TUNE
TONE2
ON
0
FINE TUNE
FILTER-LFO 1
DEPTH
FILTER-ENVELOPE
R
SA
DEPTH
D
AMP-LFO 1
DEPTH
AMP-ENVELOPE
R
SAD
FILTER
AMP
0
FILTER
CUTOFF
LPF
BPF
HPF
PKG
RESONANCE
WAVE
PITCH
SELECT
COARSE TUNE
FILTER
TYPE
RND PAN
RATE
A003
6
5
3
4 4
7
8
10
9
11
2
181
Chapter 16. Advanced Applications
16
1. Execute the Patch Initialize operation to set
the patch to the standard settings (the
Initial Patch) (p. 62).
2. Turn on TONE1 and TONE2. (Hereafter, set
TONE1 and TONE2 to the same settings
unless otherwise specified.)
3. Use [WAVE SELECT] to select the A003
waveform.
4. Rotate the TONE1 and TONE2 [FINE TUNE]
knobs to the positions shown in the dia-
gram (T1=+3, T2=-3).
This will give the bass sound greater thickness.
5. Rotate the [CUTOFF] knob to the position
(0) shown in the diagram.
There will be no sound.
6. Move the F-ENV section [DEPTH] slider to
the position (+43) shown in the diagram to
determine the overall tonal character.
7. Move the F-ENV section [A]Ð[R] sliders to
the positions shown in the diagram to
specify how the tonal character will change
over time (A=0/D=24/S=90/R=18).
8. Rotate the [RESONANCE] knob to the posi-
tion (68) shown in the diagram to create
the tonal character that is typical of synth
bass sounds.
9. Press [SOLO] to turn on the Solo switch.
Now you will be able to play single notes.
10. Press PORTAMENTO [ON] to turn on
Portamento.
11. Rotate the [TIME] knob to the position
(11) shown in the diagram to adjust the
amount of portamento.
As an effect, you may wish to apply a short delay.