Owner`s manual

Sequencer Does Not Function
(Pattern Playback, RPS
Playback, etc.)
¥ The Sync Mode is set to ÒSLAVE.Ó
☞ Set the Sync Mode to ÒINTÓ (p. 166).
If nothing happens if you press [STOP] when the
[PLAY] indicator is lit, turn the power off and on
again, and set Sync Mode to ÒINT.Ó
Reverb/Delay/EFX Do Not Apply
¥ Reverb/Delay/EFX are turned off.
☞ Hold down [EFFECT SELECT], and press [PRE-
SET]/ [USER]/ [CARD] to turn them on (p. 80, 83,
87).
¥ The Reverb Level setting and the Part Reverb
Level settings of each part are set to Ò0.Ó
☞ Increase the settings (p. 80).
¥ The Delay Level setting and the Part Delay Level
settings of each part are set to Ò0.Ó
☞ Increase the settings (p. 84).
¥ The EFX Output Level is Ò0.Ó The Part EFX/
Output Assign settings of each part are not set to
ÒEFX.Ó
☞ Increase the EFX Output Level. Set the Part EFX /
Output Assign settings to ÒEFXÓ (p. 104).
¥ The Rhythm Tone Reverb Level or Rhythm Tone
Delay Level of each note of the rhythm set you are
using is set to Ò0.Ó The Rhythm Tone EFX/Output
Assign setting for each note is not set to ÒEFX.Ó
☞ Increase the Rhythm Tone Reverb Level and the
Rhythm Tone Delay Level of each note. Set the
Rhythm Tone EFX/Output Assign settings to
ÒEFXÓ (p. 76).
Pitch Is Incorrect
¥ The tuning of the MC-505 or of the external MIDI
sound generator is incorrect.
☞ Check the tuning setting (p. 163).
The Pitch Has Been Changed by
a Pitch Bend Message That Was
Transmitted from the Sequencer
or from an External MIDI Device.
☞ Perform A MIDI Update (p. 30).
Play Quantize Does Not Apply
¥ Either the Strength setting is at 0%, or the Shuffle
Rate setting is at 50%.
☞ Set an appropriate value for the Strength or Shuffle
Rate (p. 114, 115, 117).
¥ [QUANTIZE SELECT] has not been used to speci-
fy the part(s) to which Play Quantize will be
applied.
☞ Specify the parts to which Play Quantize will be
applied (p. 113).
Notes Are Delayed or Unsteady
During Playback
¥ If you create a pattern that contains an extremely
large amount of data, or if you input an excessive
amount of knob data, notes may be delayed or
unsteady during playback. This problem can also
occur if the tempo is speeded up excessively, or
for some combinations of Megamix.
☞ Delete unneeded note data or knob data. Use Data
Thin to thin out knob data (p. 152).
☞ Use Move Event to move notes that were input at
the same location as chords, so that they are stag-
gered by 1 clock (p. 143).
☞ Use Shift Clock to move data of parts other than the
rhythm part backward by 1 clock (p. 151).
187