Owner`s manual
If an incorrect operation has been performed or if pro-
cessing could not be carried out as specified, an error
message will appear. Refer to this list and take the
appropriate action.
fig.17-1
¥ There is a problem with the MIDI cable connec-
tions.
☞ Make sure that MIDI cables have not been pulled
out or broken (Quick Start; p. 3).
fig.17-2
¥ More MIDI messages were received at once than
the MC-505 was able to process.
☞ Reduce the amount of MIDI messages that are
being transmitted to the MC-505.
fig.17-3
¥ More recording data was received at once than the
MC-505 was able to process.
☞ Reduce the amount of recording data that is being
transmitted to the MC-505.
fig.17-4
¥ The checksum value of the received system exclu-
sive message is incorrect.
☞ Correct the checksum value.
fig.17-5
¥ Since the maximum number of notes that can be
recorded in a single pattern has been reached, fur-
ther pattern recording is not possible.
☞ Delete unneeded data from the pattern that you are
recording (p. 147).
fig.17-6
¥ Since the maximum number of patterns that can
be registered in a single song has been reached,
further song recording is not possible.
☞ A maximum of 50 patterns can be registered in a
single song. No further patterns can be registered.
fig.17-16-1
¥ Recording is not possible because Megamix mode
is selected.
☞ Write the pattern, and then record.
fig.17-7
¥ Since there is insufficient user memory, the pat-
tern cannot be saved.
☞ Either initialize an unneeded pattern, or save the
data to a memory card.
fig.17-8
¥ Since there is insufficient card memory capacity,
the pattern cannot be saved.
☞ Either initialize an unneeded pattern, or save the
data to internal memory.
fig.17-8
¥ Since a different time signature is set for the copy
source and copy destination patterns, the pattern
copy is not possible.
☞ The pattern copy operation can only be used for
patterns with the same time signature.
fig.17-9
Error Message List
188