Owner`s manual

1. Hold down [EDIT] and press a keyboard
pad [13], [14] or [15].
[13]: The CONTROL/MOD section setting page will
appear, and you can make settings for the para-
meter that will be controlled by the modulation
lever.
[14]: The CONTROL/PITCH BEND section setting
page will appear, and you can make settings for
the parameter that will be controlled by the pitch
bend lever.
[15]: The CONTROL/AFTER TOUCH section setting
page will appear, and you can make settings for
the parameter that will be controlled by after-
touch.
2. Use PAGE [<] [>] to select parameters with-
in the section, and edit them.
fig.3-83
Adjusting the Range of Pitch
Bend (Bend Range)
(PITCH BEND Section Only)
Bend Up/Down (Bend Range Up/Down)
Specifies the amount of pitch change (in semitone
units) that will occur when the pitch bend lever of an
external MIDI device is operated. You can make inde-
pendent settings for movement to the right (raising the
pitch) and left (lowering the pitch).
Available settings:
Bend Range Up: 0Ð+12
Bend Range Down: 0Ð-48
Higher settings will result in a greater pitch change
when the pitch bend lever is moved to the left or right.
For example, if Bend Range Up is set to Ò+12,Ó the
pitch will rise one octave when the pitch bend lever is
moved to the right-most position.
Control 1/2/3/4 (Control
Destination 1/2/3/4)
Select the parameters that will be controlled when
each controller of the external MIDI device is operat-
ed. For each controller, you can assign up to four para-
meters for each tone (Control 1 through Control 4).
Available settings:
OFF: No control
PCH: Pitch
CUT: Cutoff Frequency (p. 40)
RES: Resonance (p. 41)
LEV: Tone Level (p. 45)
PAN: Tone Pan (p. 46)
L1P: LFO1 Pitch Depth (Vibrato) (p. 54)
L2P: LFO2 Pitch Depth (Vibrato) (p. 54)
L1F: LFO1 Filter Depth (Wah) (p. 54)
L2F: LFO2 Filter Depth (Wah) (p. 54)
L1A: LFO1 Amplifier Depth (Tremolo) (p. 54)
L2A: LFO2 Amplifier Depth (Tremolo) (p. 54)
L1p: LFO1 Pan Depth (p. 54)
L2p: LFO2 Pan Depth (p. 54)
L1R: LFO1 Rate (p. 52)
L2R: LFO2 Rate (p. 52)
Ctrl 1/2/3/4 Depth (Control
1/2/3/4 Depth)
Specifies the amount of change that will occur for each
parameter selected as a control destination.
Range: -63Ð+63
With positive (+) settings, higher values will allow
greater control.
With negative (-) settings, the direction of the change
will be inverted.
* Parameters that are modified using controllers are modi-
fied only temporarily. The value of the parameter itself is
not directly changed.
PAG EPAG E
REALTIME ERASE
EDIT
13
REALTIME ERASE
EDIT
14
REALTIME ERASE
EDIT
15
Chapter 3. Creating Original Sounds (Patch Edit/Rhythm Edit)
60
3