Owner`s manual

(Reverb)Ó (p. 79)

R.TONE Dly Level

(Rhythm Tone Delay Level)

Specifies the amount of delay for each rhythm tone.

Range: 0Ð127

Higher settings will increase the delay volume.

* The Rhythm Tone Delay Level setting is valid only when

the Part EFX/Output Assign setting of the rhythm part is

set to ÒRHY.Ó Also in this case, if the Delay Level and the

Part Delay Level setting of the rhythm part are low, there

will be no delay even if the Rhythm Tone Delay Level is

raised.

☞ ÒApplying EFX/Specifying the Output

Destination for Each Part (Part EFX/Output

AssignÓ (p. 104)

☞ Adjusting the Overall Delay Volume (Delay

Level) (p. 84)

☞ Adjusting the Delay Volume for Each Part

(Part Delay Level) (p. 84)

¥If you would like to know more about delay

settings...

☞ ÒAdding an Echo to the Sound (Delay)Ó (p. 82)

R.TONE EFX/Out (Rhythm Tone

EFX/Output Assign)

For each rhythm tone, you can turn EFX on/off and

specify the output jacks from which the sound will be

output. Make these settings when you wish to apply

EFX only to specific rhythm tones, or to output only

specific rhythm tones from the DIRECT 1/2 jacks.

Available settings:

DRY: Stereo output from the MIX jacks without

applying EFX (EFX off).

EFX: Apply EFX, and output in stereo from the MIX

jacks (EXF on).

DIR1: Stereo output from the DIRECT 1 jacks.

DIR2: Stereo output from the DIRECT 2 jacks.

* Rhythm Tone EFX/Output Assign settings are valid only

when the Part EFX/Output Assign setting of the rhythm

part is ÒRHY.Ó

☞ ÒApplying EFX/Specifying the Output

Destination for Each Part (Part EFX/Output

Assign)Ó (p. 104)

* Effects (reverb/delay/EFX) are not applied to the sound

that is output from the DIRECT 1/2 jacks.

Chapter 3. Creating Original Sounds (Patch Edit/Rhythm Edit)