Owner`s manual

Compressor (Make the Volume
Level More Consistent)
This effect suppresses loud volume levels and boosts
soft volume levels, making the volume more consis-
tent.
fig.4-37
Attack [CTRL 1]
Specifies the duration of the attack when sound is
input.
Range: 0Ð127
Sustain [CTRL 2]
Specifies the time over which low-level sounds will be
boosted to reach the specified volume.
Range: 0Ð127
Post Gain
Adjusts the output signal.
Range: 0, +6, +12, +18
Low Gain
Adjusts the boost or cut of the low frequency range.
Range: -15Ð+15
High Gain [CTRL 3]
Adjusts the boost or cut of the high frequency range.
Range: -15Ð+15
Output Level [EFX OUTPUT LEVEL]
Specifies the output volume from the Compressor
effect.
Range: 0Ð127
Limiter (Smooth Out
Irregularities in Volume)
This effect compresses the sound when it exceeds a
specified volume level, thus preventing distortion.
fig.4-38
Threshold (Threshold Level) [CTRL 1]
Specifies the volume level at which compression will
begin.
Range: 0Ð127
Ratio (Compression Ratio) [CTRL 2]
Specifies the ratio of compression.
Range: 1.5:1, 2:1, 4:1, 100:1
Release [CTRL 3]
Specifies the time from when the volume drops below
the Threshold Level until compression is no longer
applied.
Range: 0Ð127
Post Gain
Adjusts the output signal.
Range: 0, +6, +12, +18
Output Pan
Specifies the stereo location of the output from the
Limiter effect.
Range: L64Ð63R
Output Level [EFX OUTPUT LEVEL]
Specifies the output volume of the Limiter effect.
Range: 0Ð127
LIMITER
Threshold
Ratio
Release
Output Level
COMPRESSOR
Attack
Sustain
High Gain
Output Level
Chapter 4. Applying Effects to the Sound (Effects)
93
4