Owner`s manual

Tremolo
(Cyclic Changes in Volume)
This effect cyclically modulates the volume to create
tremolo.
fig.4-41
LFO Type [CTRL 3]
Determines the waveform that will be used to modu-
late the sound.
Range: TRI, TRP, SIN, SAW1, SAW2, SQR
Rate [CTRL 2]
Specifies the frequency of modulation.
Range: 0.1Ð10.0,
2MES 3MES 4MES 8MES 16MES
If a note value or measure is selected as the value of
this parameter, the Rate will synchronize with the
tempo of the pattern at intervals of the specified note
value or measure.
If you wish to use the [CTRL 2 (RATE)] knob to select
a note value or measure, hold down [SHIFT] and
rotate the [CTRL 2 (RATE)] knob.
fig.4-43
Depth [CTRL 1]
Specifies the depth of modulation.
Range: 0Ð127
Low Gain
Adjusts the boost or cut of the low frequency range.
Range: -15Ð+15
High Gain
Adjusts the boost or cut of the high frequency range.
Range: -15Ð+15
Output Level [EFX OUTPUT LEVEL]
Specifies the output volume of the Tremolo effect.
Range: 0Ð127
Phaser (Modulate the Sound)
By adding a phase-shifted sound to the original sound,
this effect modulates the sound to add depth and a
sense of rotation.
fig.4-44
Manual
Specifies the center frequency at which the sound will
be modulated.
Range: 100Ð8000 (Hz)
Rate [CTRL 2]
Specifies the frequency of modulation.
Range: 0.1Ð10.0,
2MES 3MES 4MES 8MES 16MES
If a note value or measure is selected as the value of
this parameter, the Rate will synchronize with the
tempo of the pattern at intervals of the specified note
value or measure.
If you wish to use the [CTRL 2 (RATE)] knob to select
a note value or measure, hold down [SHIFT] and
rotate the [CTRL 2 (RATE)] knob.
Depth [CTRL 1]
Specifies the depth of modulation.
Range: 0Ð127
PHASER
Depth
Rate
Resonance
Output Level
EFX
CTRL2
SHIFT
TREMOLO
Depth
Rate
LFO Type
Output Level
Chapter 4. Applying Effects to the Sound (Effects)
95
4