Owner`s manual

Resonance [CTRL 3]
This setting emphasizes the frequency range in the
vicinity of the center frequency.
Range: 0Ð127
Mix (Mix Level)
Adjusts the proportion of the original sound that will
be combined with the phase-shifted sound.
Range: 0Ð127
Output Pan
Specifies the stereo location of the output from the
Phaser effect.
Range: L64Ð63R
Output Level [EFX OUTPUT LEVEL]
Specifies the output volume of the Phaser effect.
Range: 0Ð127
Chorus (Add Spaciousness and
Depth to the Sound)
This effect creates an impression of multiple sound
sources in unison (Chorus effect), giving spaciousness
and depth to the sound.
fig.4-46
Pre Delay (Pre Delay Time)
Specifies the time from the original sound until when
the chorus sound is heard.
Range: 0.0Ð100
Rate [CTRL 2]
Specifies the frequency of modulation.
Range: 0.1Ð10.0,
2MES 3MES 4MES 8MES 16MES
If a note value or measure is selected as the value of
this parameter, the Rate will synchronize with the
tempo of the pattern at intervals of the specified note
value or measure.
If you wish to use the [CTRL 2 (RATE)] knob to select
a note value or measure, hold down [SHIFT] and
rotate the [CTRL 2 (RATE)] knob.
Depth [CTRL 1]
Specifies the depth of modulation.
Range: 0Ð127
Phase [CTRL 3]
Adjusts the spaciousness of the sound.
Range: 0Ð180
As this setting is increased, the sound will spread
more toward left and right.
Filter Type
Determines the type of filter that will be applied to the
chorus sound.
Available Settings:
OFF: A filter will not be used.
LPF: The frequency range above the cutoff frequen-
cy will be cut.
HPF: The frequency range below the cutoff frequen-
cy will be cut.
Cutoff (Cutoff Frequency)
Specifies the cutoff frequency of the filter.
Range: 200Ð8000 (Hz)
Balance (Effect Balance)
Adjusts the volume balance between the original
sound and the chorus sound.
Range: D100:0EÐD0:100E
With a setting of ÒD100:0E,Ó no chorus sound will be
output.
Output Level [EFX OUTPUT LEVEL]
Specifies the output volume from the stereo chorus.
Range: 0Ð127
CHORUS
Depth
Rate
Phase
Output Level
Chapter 4. Applying Effects to the Sound (Effects)
96
4