Owner`s manual

Space-D
(Add Transparent Depth)
This is a type of chorus, but unlike a conventional cho-
rus, it does not create a sense of modulation. It produces
a chorus effect with an impression of transparency.
fig.4-48
Pre Delay (Pre Delay Time)
Specifies the time from the original sound until the
chorus sound is heard.
Range: 0.0Ð100
Rate [CTRL 2]
Specifies the rate of modulation.
Range: 0.1Ð10.0,
2MES 3MES 4MES 8MES 16MES
If a note value or measure is selected as the value of
this parameter, the Rate will synchronize with the
tempo of the pattern at intervals of the specified note
value or measure.
If you wish to use the [CTRL 2 (RATE)] knob to select
a note value or measure, hold down [SHIFT] and
rotate the [CTRL 2 (RATE)] knob.
Depth [CTRL 1]
Specifies the depth of modulation.
Range: 0Ð127
Phase [CTRL 3]
Adjusts the spread of the sound.
Range: 0Ð180
As this value is increased, the sound will have a
broader left/right spread.
Low Gain
Adjusts the boost or cut of the low frequency range.
Range: -15Ð+15
High Gain
Adjusts the boost or cut of the high frequency range.
Range: -15Ð+15
Balance (Effect Balance)
Adjusts the volume balance between the original
sound and the chorus sound.
Range: D100:0EÐD0:100E
With a setting of ÒD100:0EÓ the chorus sound will not
be heard.
Output Level [EFX OUTPUT LEVEL]
Specifies the output volume from the Space-D effect.
Range: 0Ð127
Tetra Chorus (Layer Chorus
Sounds to Add Spaciousness)
This effect layers four chorus sounds to produce even
more depth and spaciousness than a conventional cho-
rus.
fig.4-50
Pre Delay (Pre Delay Time)
Specifies the time from the original sound until the
chorus sound is heard.
Range: 0.0Ð100
TETRA-CHORS
Depth
Rate
Pan Devi
Output Level
SPACE-D
Depth
Rate
Phase
Output Level
Chapter 4. Applying Effects to the Sound (Effects)
97
4