Owner`s manual

Feedback (Feedback Level) [CTRL 3]
Specifies the proportion of the flanger sound that is
fed back into the input.
Range: 0Ð+98 (%)
Phase
Adjusts the width of the sound.
Range: 0Ð180
As this setting is increased, the left/right spread of the
sound will increase.
Filter Type
Determines the type of filter that will be applied to the
flanger sound.
Available Settings:
OFF: A filter will not be used.
LPF: The frequency range above the cutoff frequen-
cy will be cut.
HPF: The frequency range below the cutoff frequen-
cy will be cut.
Cutoff (Cutoff Frequency)
Specifies the cutoff frequency of the filter.
Range: 200Ð8000 (Hz)
Balance (Effect Balance)
Adjusts the volume balance between the original
sound and the flanger sound.
Range: D100:0EÐD0:100E
With a setting of ÒD100:0E,Ó no flanger sound will be
output.
Output Level [EFX OUTPUT LEVEL]
Specifies the output volume from the stereo flanger.
Range: 0Ð127
Step Flanger (Add Metallic
Resonance to the Sound While
Changing the Pitch in Steps)
This is a flanger that changes the pitch of the sound in
steps. The frequency of pitch change can also be syn-
chronized to the tempo.
fig.4-54
Pre Delay (Pre Delay Time)
Specifies the time from the original sound until the
flanger sound is heard.
Range: 0.0Ð100
Rate [CTRL 2]
Specifies the rate of modulation.
Range: 0.1Ð10.0,
2MES 3MES 4MES 8MES 16MES
If a note value or measure is selected as the value of
this parameter, the Rate will synchronize with the
tempo of the pattern at intervals of the specified note
value or measure.
If you wish to use the [CTRL 2 (RATE)] knob to select
a note value or measure, hold down [SHIFT] and
rotate the [CTRL 2 (RATE)] knob.
Depth [CTRL 1]
Specifies the depth of modulation.
Range: 0Ð127
ST-FLANGER
Depth
Rate
Step Rate
Output Level
Chapter 4. Applying Effects to the Sound (Effects)
99
4