User`s manual
1-2 Installation
Installation Environment
Install in a quiet, stable location oering good operating conditions. An unsuitable location can cause accident,
re, faulty operation, or breakdown.
CAUTION
Install in a location that is level and stable.
Installation in an unsuitable location may cause an accident, including a fall
or tip over.
Never install in a location subject to wide uctuations in temperature or humidity.
Never install in a location subject to shaking or vibration.
Never install in a location where the oor is tilted, not level, or unstable.
Never install in a dusty or dirty location, or out of doors.
Never install in a location exposed to direct sunlight or near air-conditioning or heating equipment.
Never install in a location exposed to considerable electrical or magnetic noise, or other forms of electro-
magnetic energy.
Never install in an environment where silicone substances (oil, grease, spray, etc.) are present.
Removing and storing the retainers
Retaining materials are attached to protect the machine from vibration during shipment. Remove these after
emplacement.
Remove all Retaining materials. Any that remain may cause faulty operation or breakdown when the power
is switched on.
The retaining materials and package are required when moving the machine to a dierent location. Store
them carefully so that they do not get misplaced.
The machine is secured at three points (with 5 screws and 2 retainers). Remove all the screws and retainers
with the provided hexagonal wrench.
Keep the screws and retainers by mounting them to the lower back side of the machine.
Storing
Retainer
Hexagonal
wrench
Removing
Retainer
15
Chapter 1 Getting Started