User`s manual

35
Chapter 2 Printing
2-2 Starting Printing
STEP 1: Loading the Instrument to be Imprinted
Decide whether you use the vise or table as a retainer depending on the size or shape of the instrument to be
imprinted. The criteria used to select the vise or table are as follows:
 Vise  The size and shape of the instrument that can be xed by vise.
 Table  The instrument has a at bottom and the size and shape of the instrument that can
not be xed by vise.
1. Attach the head cap.

Make sure that preparations for printing are completed.
 P. 26, "2-1 Preparing for Printing"

If the head unit is lowered, press the Power/Movement button.
The head moves to the left rear.

Loosen the head's stopper.
The stopper and ring contact each other.

Fix the head's stopper.
Align the center of the knob with the top of the tri-
angle right below and then secure the stopper.
If you printing as the stopper is loose, the knob might
come o due to vibration.
Ring
Stopper
Loosen
Knob
The center of the knob must
be positioned immediately
above the top of the triangle.
Tighten