User`s manual

41
Chapter 2 Printing
2-2 Starting Printing

Load the instrument to be imprinted on the adhesive sheet.
Move the table so that laser pointer points at the center of the area to be imprinted.
Gently press the instrument to be imprinted in a way that you ax it to the adhesive sheet.
If the instrument protrudes from the table and the instrument tilts, place a support in order to keep the
instrument horizontal.
If you print using the head cap, this completes loading of the instrument to be imprinted. Go to
"STEP 2: Making Prints."
If you use no head cap, go to the following step
3.
.
The position to which the laser pointer points coincides with the center of the work area in METAZAStu-
dio. By making the position to which the laser pointer points coincide with the center of the area to
be imprinted, you can print with the exactly same layout as the one displayed on the METAZAStudio's
work area.
Using the head cap is usually recommended.
When the head cap is used, the machine automatically tracks the surface height of material and sets
the position of the head. You can make a print on a curved surface. (There is an upper limit of the
height that can be tracked.) It is recommended to use the head cap for usual printing.
The area to be imprinted
Laser pointer