User`s manual

5
3-3 Loading the Material
Below are shown the allowable widths (horizontal dimension) of materials that can be loaded and the maximum widths that can be
cut.
Reference — Material Loading Position
Acceptable material widths
PNC-1860 : 90—1372 mm (3-1/2"—54" )
PNC-1410 : 90—1067 mm (3-1/2"—42" )
PNC-1210 : 50—762 mm (1-15/16"—30" )
Maximum cutting area
PNC-1860 : 1195 mm (W) x 24998 mm (L) (47" x 984-1/8")
PNC-1410 : 889 mm (W) x 24998 mm (L) (35" x 984-1/8")
PNC-1210 : 585 (W) mm x 24998 mm (L) (23" x 984-1/8")
There is no particular restriction on material length (vertical dimension). This means that you can use either flat materials such as
standard-size materials (ANSI, ISO, etc.) and cut materials, or roll materials. The grit rollers (pinch rollers that secure the material)
vary from one model to another, and settable ranges are determined for the left and right movable pinch rollers. Setting a pinch roller
outside the allowed range causes an error message to appear.
PNC-1410
• The middle pinch roller is used as an auxiliary roller. Be sure to use the left and right pinch rollers to secure the
material in place.
• When loading a material, make sure that it passes over the material sensor above the platen. The size of the material
cannot be determined unless the material passes over the sheet sensor.
(1*) Position of the pinch roller (middle) when using material with a width of 30"
(2*) Position of the pinch roller (middle) when using material with a width of 36" or 42"
(3*) Position of the pinch roller (middle) when using material with a width of 48" or 54"
PNC-1860
The right-hand movable pinch roller can be moved within this range.
When loading material with a width other than one indicated above, move the right-hand movable pinch roller.
:Movable Pinch
Roller (Left)
: Movable Pinch
Roller (Right)
: Movable Pinch
Roller (Middle)
:Grit Roller
54" (approx.1372 mm)
Material with a
width of 6"
* Do not set the pinch roller here.
42" (approx.1067 mm)
Material
(1*)
(2*)
(1*)(2*)
(3*)
12" (approx. 305 mm)
24"
(approx. 610 mm)
30"
(approx. 762 mm)
36"
(approx. 914 mm)
42"
(approx. 1067 mm)
48"
(approx. 1219 mm)
18"
(approx. 457 mm)
54"
(approx. 1372 mm)
6"
(approx. 152 mm)
Material with
a width
of 12"
Material with
a width
of 18"
Material with
a width
of 24"
Material with
a width
of 30"
Material with a
width of 6"
Material with
a width
of 12"
Material with
a width
of 18"
Material with
a width
of 24"
Material with
a width
of 30"
Material with
a width
of 36"
Material with
a width
of 42" and 36"
Material with
a width
of 42"
Material with
a width
of 48" and 54"
* Do not set the pinch roller here.