User`s manual

6
Stopper
If the diameter of the rolled sheet
core is 72 mm (2-7/8") or less
Install the shaft here if the amount
of sheet remaining is small.
Shafts
* One shaft should always be
installed here.
Install the shafts to match either
the remaining amount (roll width)
of the sheet, or the diameter of
the rolled sheet s core.
* Do not use with shafts installed
at both of these positions at the
same time.
Rear
Front
Place the rolled
sheet here.
Sheet hangers
Front
Shaft
Stopper
Rear
Side view of loaded
roll material
Loading Roll Material
When using stand (The stand is sold separately.)
(PNC-1860: PNS-186, PNC-1410:PNS-141, PNC-1210: PNS-130)
(1) Install the two shafts on the sheet hanger.
(2) Place the roll material on top of the shafts.
PNC-1210
The PNC-1210 has no middle pinch roller.
PNC-1860
Roland DG Corp.
PNC-1860
Power ON
PNC-1410
Roland DG Corp.
PNC-1410
PNC-1210
Roland DG Corp.
PNC-1210
Turning on the Power
Switch on the power switch on the front of
the main unit.
The right-hand movable pinch roller can be moved within this range.
When loading material with a width other than one indicated above, move the right-hand movable pinch roller.
30" (approx. 762 mm)
* Do not set the pinch roller here.
Material
Material with a
width of 6"
Material with
a width
of 12"
Material with
a width
of 18"
Material with
a width
of 24" and 30"
12" (approx. 305 mm)
24"
(approx. 610 mm)
30"
(approx. 762 mm)
18"
(approx. 457 mm)
6"
(approx. 152 mm)