User`s manual

10
To Perform Long Cutting
AREA LENGTH
MOVE < 1.0m>
AREA LENGTH
MOVE < 2.0m>
1 CUT 50cm/s
0.250mm 30gf
WIDTH LENGTH
14612 ------
PRESS SETUP KEY
SELECT SHEET
ROLL EDGE PIECE
AREA AXIS
REPLOT SUBMENU
Press .
Press .
Press
Press or to
.
Press .
select [ROLL].
Press .
Press or to
select [AREA].
Press .
Press or to
select [MOVE].
Press or to select the value.
Press or to change the value.
Set this to the
length of the
material to be
cut.
Use the control panel to make the following settings.
6
The set length of material is fed out.
Make sure that the material remains held by the pinch rollers.
If the material does come loose from the pinch rollers, set it in place again.
2
3
Guide lines
25 mm
(1")
or more
Guide lines
25 mm
(1")
or more
1
Pull out the material from the roll
and pass it through the unit.
5
Close the front cover.
Use material that is wider by 50 mm (2") or more
than the width of the cutting to be performed.
Pull out the amount of roll
material to be used.
4
When performing cutting over a length of 1.5 m (60") or more, first feed out the required length of material. Then follow
the steps below to load the material.