User`s manual

Continuing Cutting

Cutting after changing the material

Again carry out the procedure described from “3-3 Loading the Material” to “3-6 Downloading Cutting Data” .

* There is no need to perform the procedure described under “3-4 Selecting the Interface.” Also, if a material of the

same type is used, there is no need to perform a cutting test.

Continuing cutting on the same material

Set the origin point for the place where cutting is to be performed next. If the material has

not been fed to the cutting point when using roll materials, use the “AREA” function on the

display menu to feed the material. Press the key until the screen shown at right appears. Use

the

, , and keys to move the tool carriage to the desired location. Press the

ENTER

key to set the origin point.

ORIGIN SET->ENTER

AREA ROTATE

REPLOT SUBMENU

REPLOT

START CLEAR

AREA ROTATE

REPLOT SUBMENU

REPLOT

START CLEAR

Repeating the same cutting

The "Replot" feature allows you to create numerous copies of same cutting.

(1) Press the

key until the screen shown at right appears, then use the and keys to

select "Replot" and press the

ENTER

key.

(2) Use the

and keys to select "Start," then press the

ENTER

key to begin replotting.

The Replot function calls up all data in the data buffer and performs cutting with this data. When performing replotting, follow

the steps below to delete the data in the data buffer before send the data to be replotted from the computer.

(1) Press the

key until the screen shown at right appears, then use the and keys to

select "Replot" and press the

ENTER

key.

(2) Use the

and keys to select "Clear" and press the

ENTER

key to delete the data in the

data buffer.