User`s manual

17
5 ABOUT THE CUTTING AREA
6 USING THE DISPLAY MENUS
This section describes the basic steps for using the display menus. Use this information together with "7 Display Menu Flowchart" on
the following page to make menu settings.
AREA AXIS
REPLOT SUBMENU
1 CUT 50cm/S
0.250 30gf
MENU
ENTER
ENTER
Press the key to change to
the next menu
AREA LENGTH
MOVE <1.0m>
ROTATE
<0deg> 90deg
ENTER
Then use the and keys to change the value and
enable the setting by pressing the key
Use the and keys to move the
blinking cursor (" ") and choose a setting
Press the key to advance
to the next setting screen
Select "AREA"
The value enclosed in angled brackets ("<>") is the current setting
The selection enclosed in angled brackets ("<>") is the current setting
MENU
Use the and keys to move the blinking cursor (" ") and choose a setting.
Then use the and keys to change the value (or the selection) and enable the setting by pressing the key.
Use the and keys to move the blinking cursor
(" ") and choose a setting
• To return to the menu selection screen from any of the menu
value setting screens, press the
MENU
key.
• To return to the previous screen without changing the numerical
settings, pressing the
MENU
key without pressing the
ENTER
key.
* The pairs of allows
indicate the positive
direction along the X
and Y axis.
Acceptable material widths
PNC-1860 : 90—1372 mm (3-1/2"—54" )
PNC-1410 : 90—1067 mm (3-1/2"—42" )
PNC-1210 : 50—762 mm (1-15/16"—30" )
The cutting area along the horizontal plane (the direction in which the tool carriage moves) is determined by the position of the pinch
rollers. The workable area spans the length between the two rollers, minus a margin of about 1 mm (about 0.04") on both sides.
If the material length is greater than 1,600 mm (62-15/16") when a flat material (paper) has been loaded, the PNC-1860/1410/
1210 determines it to be a rolled material and sets the material length to 24,998 mm (984-1/8").
Maximum cutting area
PNC-1860 : 1195 mm (W) x 24998 mm (L) (47" x 984-1/8")
PNC-1410 : 889 mm (W) x 24998 mm (L) (35" x 984-1/8")
PNC-1210 : 585 (W) mm x 24998 mm (L) (23" x 984-1/8")
PNC-1860
PNC-1410
PNC-1210
1195 mm (47")
889 mm (35")
585 mm (23")
24998 mm (984-1/8")
10 mm
(3/8")
Approx. 1 mm
(about 0.04")
Cutting coordinates origin (0,0)
Movable pinch roller (left)
Cutting area
Sheet
Movable pinch roller (right)
Approx. 15 mm
(about 9/16")