User`s manual

19
HANDSHAKE
<H-WIRE>XON/OFF
BAUD RATE
19200 <9600>
PARITY MODE
<NONE>ODD EVEN
DATA BIT
7 <8>
STOP BIT
<1> 2
PROTOCOL 2
BAUD HANDSHAKE
PROTOCOL 1
STOP DATA PARITY
ORIGIN SET->ENTER
0 0
PAUSE ON
CONT. STOP VIEW
AREA MENU UNIT
<METRE> FEET
INTERFACE
PARA SERI<AUTO>
COMMAND MODE
1 2 <AUTO>
UNIT AREAUNIT
TOOL-CHG PREFEED
FS COMMAND
<IGNRORE>EFFECT
VS COMMAND
<IGNRORE>EFFECT
VS-CMND FS-CMND
COMMAND I/O
MENU
MENU
FS-CMND
VS-CMND
PEN
-CHG
IGNORE / ACCEPT
IGNORE / ACCEPT
IGNORE / ACCEPT
ENTER
MENU
MENU
COMMAND
I/O
AREA
UNIT
SMOOTHING
1 (mode 1) / 2 (mode 2) / AUTO
PARA (Parallel) / SERI (Serial) / AUTO
MENU
1/2
7 / 8
NONE / EVEN / ODD
STOP
DATA
PARITY
BAUD
HAND-
SHAKE
2400 / 4800 / 9600 / 19200
H-WIRE (Hardwire) / XON/OFF
METRE / FEET
MENU
Select [END.]
Press .
ENTER
Pressing moves the blade up or down.
Pressing , , , or moves the cutter in
the +Y, -Y, -X, or +X directions, respectively.
BAUD RATE
4800 2400
When set to [SERIAL]
or [AUTO] (communicati
on parameter setting)
PAUSE -> ENTER
PAUSE .
Press
Use , , , and to move the tool
carreage and sheet to the position on the
sheet where the origin point is to be set.
ENTER
to enable the setting.
Press
MENUMENU
Cutting Machine is
performing cutting
CONT: Cutting is continued (resumed)
STOP: Cutting is stopped (cutting
performed for data already
received)
VIEW: The tool carriage moves to the right side
DISPLAY UNIT
<MACHINE> MILI
UNIT
MACHINE / MILI (Milimeter)
MENU
AUTO PREFEED
<OFF> ON
PREFEED
OFF / ON
OFF / ON
CALIB X CALIB Y
0.00% 0.00%
OVER CUT
OFF <ON>
UP/DOWN ->ENTER
MOVE ->CURSOR
CALIB
OVER CUT
UPDOWN
OFF/ON
-0.19% 0.19% (in increments of 0.01%.)
SUBMENU
CROPMARK UPDOWN
OVER-CUT CALIB
TOOL-CHG COMMAND
<IGNORE> EFFECT
SMOOTHING END
SMOOTHING
<OFF> ON