User`s manual

32
Signal
Number
Terminal
Number
Signal
Number
Pin Connection
NC 36 18 HIGH**
HIGH* 35 17 GND
NC 34 16 GND
GND 33 15 NC
HIGH* 32 14 NC
NC 31 13 HIGH*
GND
30 12 GND
29 11 BUSY
28 10 ACK
27 9 D7
26 8 D6
25 7 D5
24 6 D4
23 5 D3
22 4 D2
21 3 D1
20 2 D0
19 1 STROBE
Parallel
Standard In compliance with the specifications of Centronics
Input signals STROBE (1 BIT), DATA (8 BIT)
Output signals BUSY (1 BIT), ACK (1 BIT)
Level of input/output signals TTL level
Transmission method Asynchronous
Serial
Standard RS-232C specifications
Transmission method Asynchronous, duplex data transmission
Transmission speed 2400, 4800, 9600, 19200 (selected using panel keys)
Parity check Odd, Even, or None (selected using panel keys)
Data bits 7 or 8 bits (selected using panel keys)
Stop bits 1 or 2 bits (selected using panel keys)
Handshake DTR or Xon/Xoff (selected using panel keys)
Signal
Number
Terminal
Number
Signal
Number
Pin Connection
NC 25 13 NC
NC 24 12 NC
NC 23 11 NC
NC 22 10 NC
NC 21 9 NC
DTR 20 8 NC
NC 19 7 SG
NC 18 6 DSR
NC 17 5 CTS
NC 16 4 RTS
NC 15 3 RXD
NC 14 2 TXD
1 FG
(
*
)
The following conditions must be satisfied:
- Material type: 3M Scotchcal Mastercut Film, ARLON Series 2100
- Special stand (a roll material must be set at the rear and on the inner sheet hanger)
- Side margins: 25 mm (1") or more for both the left and right margins
- Front margin: 25 mm (1") or more
(After loading the material, using the display menu to select “EDGE” as the material type automatically sets a front margin of 25 mm (1").)
- Use of the display menu’s “AREA” function to perform feed of the material length plus 0.2 m and set the material correctly
- Cutting of the following data one time
X
Y
Origin
(1) The letters are cut in order starting with "R"
(2) After the last letter ("P") has been cut, the machine returns to the origin
point and the outer border is cut
The origin is rotated 90 degrees ("AXIS" on the display menu is set to "90deg").
Feed length
Sheets with a width exceeding 610 mm (24"): 4,000 mm (157-7/16")
Sheets with a width of 610 mm (24") or less : 8,000 mm (315-15/16")
Cut length
Fills the
hard clip
Front margin: 25 mm (1") or more
Side margins: 25 mm (1") or more
Side margins:
25 mm (1")
or more
Movable
pinch roller (left)
Movable pinch roller (right)
Cutter
protector
Interface Specifications
Specification of the Parallel interface Specification of the Serial interface
3.3K
100
+5 V
+5 V
=
=
*
**
Ω
Ω
1
19
18
36
1
14
13
25