User`s manual

1
Check the following to make sure that you received all the items that were shipped along with the unit.
Blade Holder
XD-CH2 : 1
Power Cord: 1
Blade
(Cemented Carbide blade) : 1
Alignment Tool: 1 Material for Test Cuts: 1
Test-use Application
Tape:
1
Cutter Tool: 1
Tweezers
(for handling material): 1
Test use Water Based
Fiber Tipped Pen: 1
Test-use High-quality
Paper: 1
1 CHECKING ACCESSORIES
2-1 Front View
Front Cover
This safety features prevents anything from coming into contact with the
moving parts during operation. Operation is paused if the cover is opened.
* In the figures shown, the PNC-1860 is installed on the PNS-186 special stand.
Some details of the PNC-1410/1210 differ from the figure.
2 PART NAMES AND FUNCTIONS
Cutter Protector
Movable Pinch Roller (Left)
This holds the media against the grit roller during
cutting. It can be moved from side to side, and should
be aligned with the left edge of the material.
Movable Pinch Roller (middle)
This is used when cutting materials with a
width of 762 mm or more. At this time, it is
set at the center of the left and right pinch
rollers or above the grit roller near the center.
Movable Pinch Roller (Right)
This holds the media against the grit roller
during cutting. It can be moved from side to
side, and should be aligned with the right edge
of the material.
Tool Carriage
The tool carriage is where the cutter (or pen)
is mounted. The tool carriage performs the
cutting by moving the tool left/right or up/
down.
Power Switch
ON when switched to [ ], OFF when
switched to [ ] .
Guide line
When loading a flat material, align the
right-hand edge of the material with this
guide line and load the material so that it is
perfectly straight.
Operation Panel
Grit Roller
Grasps and moves the material (or
paper) during cutting (or plotting).
Platen
User’s Manual: 1
Sheet sensor
When a material is passed through this
portion, this sensor detects the material's
cutting range.
CAMM-1 DRIVER for
windows 3.1: 1
CAMM-1 DRIVER for
windows 95: 1