User Manual-Reference Guide
12
Recording
Basic Recording Operation
Recall settings for specic
purposes
Specify the recording quality
Adjusting the Input Level
StopRecord
1. Switch on the R-07’s power (p. 6).
2. Recall the settings that are most appropriate for
your specic recording situation (p. 13).
3. Specify the audio quality of the recording (p. 14).
4. Adjust the recording level (p. 17).
5. Start recording.
If the REC/PLAY indicator is unlit, press [ ] to make it blink red,
putting the unit in recording-standby mode.
In recording-standby mode, press [
] or [ ]; the REC/PLAY
indicator is lit red, and recording starts.
MEMO
After recording starts, you can set the [POWER] switch to the
HOLD position so that accidental button presses do not stop
the recording or change the input level.
NOTE
5 The built-in mics cannot be used if a mic or other device is
connected to the MIC/AUX IN jack. If you want to use the
built-in mics, do not connect anything to the MIC/AUX IN
jack.
5 The recording level will change if you operate the INPUT [+]
[–] buttons in recording-standby mode or during recording.
Take care that you don’t inadvertently operate the INPUT [+]
[–] buttons.
5 You can’t turn o the power during recording. You must stop
recording before you can turn o the power.
6. Press [ ] to stop recording.
The REC/PLAY indicator will go out.
The display will show the le that was recorded (p. 5).
MEMO
5 To pause, press [
]. To disengage pause and resume
recording, press [ ] once again.
5 A le name such as R07_0001.WAV will be created
automatically. The 0001 portion is assigned as a number that
is one greater than the largest number of the existing les.
5 If the Recorder parameter File Name is set to “Date,” the date
and time of recording will be the le name. For details, refer
to “File Name” (p. 39).
7. Press [ ] to play back the recorded le.
For details, refer to “Basic Playback Operation” (p. 22).