User Manual-Reference Guide

41
Error Messages
This section explains the main error messages that may appear in the display.
Message Problem
Clock Initialized
Power for the internal clock was lost, so the internal clock has been initialized. Please specify the
date and time.
Battery Low
The internal batteries have run low.
Replace the batteries. Alternatively, supply power via the USB port.
Improper Song
This le is of a format that the R-07 cannot use.
Already Exists
An identically named le or folder exists. Please use a dierent name to create the le or folder.
Song Protected
The le is protected. Turn Write Protect “OFF” before you execute the operation.
Name Too Long
The name is too long.
File System Err
There is a problem with the microSD card. Format the microSD card on the R-07.
SD Unformatted
The microSD card has not been formatted. Format the microSD card on the R-07.
SD Card Full
The microSD card has insucient free space. Copy les to your computer, and free up space on
the microSD card.
Cannot Change
The le cannot be renamed because the le name contains double-byte characters.
Over 2GB
The le contains too much data.
SD Card Slow
Writing to the microSD card could not be performed fast enough. Please use a microSD card that
is known to work with the R-07. In some cases, repeated writing and deleting of les may cause
the les to become fragmented on the microSD card, impairing the processing capability. If so,
please reformat the microSD card.
SD Card Error
A problem occurred while accessing the microSD card. The microSD card might be damaged.
No Card
No microSD card is inserted. Insert an microSD card into the R-07.
SD Unsupported
The R-07 cannot use this microSD card.
HOLD is ON
Operation is not possible because the [POWER] switch is set to the HOLD position. Turn the HOLD
o if you want to perform an operation.
Now Recording
Currently recording. Stop recording if you want to perform an operation.
Now Playing
Currently playing. Stop playback if you want to perform an operation.
AGC is ON
Since Limiter is “AGC,” you cannot operate the input level buttons or the rehearsal function.
To operate these things, set the limiter to a setting other than “AGC.”