Technical data

Manual
Double Sheet Detector R1000 series E20
B0046991 / Rev. 1.6
Start-up
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone [phone] · Fax [phone]
107
Note the choices “separate“ and “common“ are available only for 4P versions
with more than one sensor connected.
During the zero adjust the following message is shown:
Fig. 49: Display during zero adjust
Note Fault messages are described in the chapter
“9 Fault messages“.
When the zero adjust is completed, the following message appears:
Fig. 50: Zero adjust successfully completed
The zero adjust is now completed.
Program parameter 7: Teach-in
Fig. 51: Status of Teach-in
Possible choices:
• off: A teach-in has not been executed
• on: A teach-in will now be performed
For performing a teach-in, select “on“ and press the ENTER key (if no teach-in was done or if a
teach-in has to be repeated).
Then the operator is requested to attach a sheet with nominal thickness:
Fig. 52: Request for attaching a sheet
Attach a sheet with nominal thickness.
Attention A sheet must be attached to the sensor without air gap. The position
of the sheet during teach-in must be the same as for normal
operation. Otherwise the measurement result could be faulty.
program par. 7
attach sheet !
program par. 6
zero adj.:active
program par. 6
zero adj.: off
program par. 7
teach-in: on